Skip to main content

View Building and Floor Statistics

Eptura Knowledge Center

View Building and Floor Statistics

For building and/or floor you can view by default the statistics, either:

  • workpoints and opportunity or the
  • workpoints and unoccupied. 

View Building Statistics


From the VBS complete the following:

  1. Use the Location Selector to select a building.
  2. By default the building icon_building_selected.png icon is selected and the Information Panel displays the building statistics.

The workpoints and the opportunity for a building display at the top right-hand side of the toolbar.

building_statistics_example_opportunity.png

In the above example:

  • 766 is the workpoints and this shows the number of total workpoints for the building.
  • 315 is the opportunity and this shows the total opportunity (calculated as the capacity minus the number of assigned people and retained (occupied) desks).

To show the Capacity and Opportunity statistics in the VBS this is a configuration setting.

  1. Navigate to Admin Settings > System Config > General > VBS.
  2. Check the Use Capacity and Opportunity checkbox.

If you want to display the Workpoints and Unoccupied statistics, then uncheck the Use Capacity And Opportunity checkbox. This changes the VBS to display the building statistics as:

building_statistics_example_unoccupied.png

In the above example:

  • 766 is the workpoints and this shows the number of workpoints for the building
  • 242 is the unoccupied and this shows the number of unoccupied and retained (unoccupied) workpoints for the building.

View Floor Statistics


Click on the floor number to view the statistics about the floor, this displays in the Information panel.

To the right of each Floor Stack, there are two numbers of importance:

  • The top number in bold text represents the total workpoints on the floor.
  • The gray number below represents the opportunity for the floor, which factors in ratio and the number of unoccupied workpoints.
  • Was this article helpful?